circuit code
英 [ˈsɜːkɪt kəʊd]
美 [ˈsɜːrkɪt koʊd]
网络 闭路码; 电路编码
双语例句
- Repairing TRS T3 sense circuit ( code 3)
修理TRST3感知电路（代码3） - If troubles in the safety air bag system are happened in actual usage, the trouble code can be stored and displayed by itself diagnosis circuit, the trouble code can be picked up when repairing and the inspection and repair work can be done by the trouble code.
使用中若安全气囊系统发生故障，其自诊断电路可存贮并显示故障代码。修理时可提取故障代码，按代码进行检查与维修。 - And the paper also presents the circuit diagram and some code in detail.
并且给出了设计电路原理图以及相关代码。 - Analyzing through the trouble example, and put forward the method of inspection and maintenance according to the trouble of broken circuit and improper contact of circuit of no-trouble code display.
结合故障实例进行分析，针对无故障码显示的线路断路和接触不良故障，提出了检测方法和维修方法。 - First of all, research the principle of the circuit of fake pseudo-noise code fuze, and therefore design a circuit of fake pseudo-noise code fuze, and figure out the frame plot of this circuit;
首先，研究伪随机码引信的工作原理，由此设计引信电路，并给出该电路的结构框图； - The major work of this dissertation contains several points shown below: ( 1) Research the circuit of fake pseudo-noise code fuze.
伪随机码引信电路的研究。 - A Prototype Circuit to Generate DS Code in IFF System
IFF系统DS码产生的硬件设计 - This paper describes the software and hardware of an embedded ethernet interface based on the chip TF-320 and uIP stack. The chart of system hardware circuit and some code frames in the web server application are provided.
采用网络服务控制芯片TF-320为核心，介绍了一种基于uIP协议栈的嵌入式以太网接口的软硬件设计，并给出了系统硬件原理框图和应用于WebServer的软件部分的代码框架结构。 - Pseudo-random code signal controlled by satellite clock was transmitted to receiver time delay via satellite antenna, native code was generated generator controlled by receiver clock, and sent it to correlator through displacement circuit, then native code and received satellite signal was calculated to gain coherent output.
卫星钟控制的伪随机码信号经卫星天线传播延时到达接收机，接收机时钟控制的发生器产生本地码，经位移码电路送至相关器与接收的卫星信号进行运算得到相关输出。 - In this dissertation, the circuit of fake pseudo-noise code fuse is researched, and simulated 、 evaluated 、 validated and analyzed with the Cadence software.
本文对伪随机码引信电路进行了研究，并使用Cadence软件进行仿真、验证以及分析。 - The conversion between NRZ and HDB3 is introduced, and the circuit of code and decode of HDB3 are designed by CPLD.
多数的数字基带信号用单极性不归零码（NRZ）表示，介绍了NRZ码与HDB3码之间的转换，用CPLD设计了HDB3码编译码器。 - A Use about Acquiring Data through Show Electrical Circuit of Seven Segment Code
一种用PC机截取七段码显示电路数据的方法 - A design of control circuit for built-in code lock in strong-box
一种保险箱暗码锁控制线路的设计 - A Converting Circuit for Binary Code to BCD Code Based on CPLD
基于CPLD的二进制码转换为二-十进制（BCD）码的电路 - Describe the methods of serial communication in Windows Platform. The serial communication between PC and GPS-OEM board are described in detail. The hardware circuit and software source code are given.
简单介绍了GPS系统，讨论了Windows环境下的串行通信方式，着重讨论计算机与GPSOEM板的串行通信，并给出硬件电路和软件源代码。 - In order to develop the property and expand the using extent of Radio Frequency ( RF) Integrated Circuit Card, a kind of system of RF Integrated Circuit Card with BCH code devices is introduced.
为了进一步提高射频IC卡系统的性能和拓宽其应用范围，介绍了一种带有BCH纠错码器件的射频IC卡系统，从而增强了系统的抗干扰能力。 - Designs the circuit of pseudorandom code phase modulation radio fuze, and studies the characteristics of this fuze.
设计了伪随机编码调相无线电引信电路，分析了该引信的工作原理。 - This article introduces the design and realization of four BCD encoder circuit take 8421 code as the example, this circuit draws out the BCD code connect with other circuit very conveniently.
以8421码为例介绍了4位BCD编码器电路的设计和实现，该电路引出的BCD编码接口可以很方便地与其他电路连接。 - The circuit-Code Simulation of inductive energy storage system of XH-1
XH-1装置电感储能系统的电路模拟 - Design of a Radio Control Circuit with Hopping Code
滚动码无线电遥控电路的设计 - In the paper we have discussed and solved the problems occurred in the process of drawing printed circuit and debugging code.
论文还讨论了在印刷电路板绘制和系统调试过程中遇到的问题及解决方法。 - A 622MB/ s Clock data Recovery Circuit for NRZ code, which is based on phase locked loop, is proposed in this paper.
文中提出了一种以锁相环为基础的622MB/sNRZ码的时钟数据恢复电路。 - The rolling code technology of KEELOQ was adopted by coding integration circuit HCS301 to code the signals;
利用KEELOQ滚动码技术，以编码集成电路HCS301对信号进行编码； - The realization architecture of DMF is studied. According to CCSDS standards, the acquisition circuit for Turbo code system is designed.
通过对DMF的几种实现结构的分析，采用倒置型FIR结构，按照CCSDS标准，设计了用于Turbo码编译码系统同步捕获电路。 - A technique of turning the circuit diagram into source code for test paper producing system
成卷系统图形代码化技术 - The circuit and program code given in the thesis are debugged and certified, and the lab system is already tested and used, which can meet the requirement and the target.
文中所涉及的电路和程序源代码已在实际应用中通过调试和使用验证，所得系统也已经过实际测试及使用，能够满足预期的设计要求和指标。 - The author also have successful designed the tracking circuit and convolution code encoder and viterbi decoder, and the simulation shows that the results are right and the module is good working.
本文还实现的码跟踪同步电路和维特比卷积码的编码器和译码器，仿真结果也证明其正确性。 - Secondly, design the power supply circuit system, the code and storage receiving section and a JTAG interface circuit, draw he circuit diagram of each module.
其次对系统的电源电路、编解码部分、存储部分、接收部分和JTAG接口电路进行了设计，给出各个模块的电路原理图。 - The microcomputer solves the course information of fluxgate probe after managed by fluxgate circuit part into digital code.
微机把磁通门电路部分处理后的磁通门探头的航向信息解算成数字码。